The top two panels of the BNB Black Matte Plexi Fightstick consist of the control panel and supporting panel. The control panel provides installation for pushbuttons. The supporting panel contains the joystick mount (as applicable to the layout) and mount for PCB. It also contains an open space for the pushbuttons, shaped to the button configuration. Both are .177" (4.49mm) thick, and possess contour screw holes for use with Set of 8 Bolts for BNB Fightsticks - Black and Set of 2 Bolts and Nuts for BNB Fightsticks PCB Mount.
All 24mm Button Panel
This particular layout uses the smaller 24mm buttons normally designated for start/mode/turbo inputs, or original HitBox. See the difference between 24mm and 30mm buttons here.
Matte Texture on One Side
The all black BnB is designed for those who love the often sleek presentation of an all black Fightstick, or black with highlights of color that can make it stand out. Gloss has the darkest color and sleekest presentation, though important to note that gloss is more difficult to keep clean or free of visible fingerprints. Matte is slghtly brighter so it will not directly match solid black accessories, but is smudge and fingerprint-resistant. Please refer to the photos below for comparison between gloss and matte texture.
Please note that the opposite side of this plexi will have a black gloss.
Pre-Wrapped in Paper or Film Backing
The panels are cut from acrylic sheets with protective brown paper or blue plastic film. You may see scratches or wear on the paper or film as the sheets are cut and transported from the acrylic manufacturer to us, and should not appear on the plexiglass once removed. To remove the film, use a fingernail on any available corner and proceed to pull away at the backing. The paper or film does not have adhesive and should not leave residue on the plexiglass.
BNB Assembled Dimensions
Here are the Width x Length x Height dimensions of an assembled BNB Fightstick:
|Side Panel Height