BNB Fightstick Gen 1 Clear Plexi Replacement Panel - All 24mm Button

The top two panels of the BNB Clear Plexi Fightstick consist of the control panel and supporting panel. The control panel protects custom artwork and provides installation for pushbuttons. The supporting panel contains the joystick mount (as applicable to the layout) and mount for PCB. It also contains an open space for the pushbuttons, shaped to the button configuration. Both are .177" (4.49mm) thick, and possess contour screw holes for use with Set of 8 Bolts for BNB Fightsticks and Set of 2 Bolts and Nuts for BNB Fightsticks PCB Mount.

All 24mm Button Panel

This particular layout uses the smaller 24mm buttons normally designated for start/mode/turbo inputs, or original HitBox.  See the difference between 24mm and 30mm buttons here. 

Pre-Wrapped in Paper or Film Backing

The panels are cut from acrylic sheets with protective brown paper or blue plastic film.  You may see scratches or wear on the paper or film as the sheets are cut and transported from the acrylic manufacturer to us, and should not appear on the plexiglass once removed.  To remove the film, use a fingernail on any available corner and proceed to pull away at the backing. The paper or film does not have adhesive and should not leave residue on the plexiglass.

BNB Assembled Dimensions

Here are the Width x Length x Height dimensions of an assembled BNB Fightstick: