BNB Fightstick Gen 2 and 3 Clear Plexi Replacement Bottom Panel

Please note that BNB Gen 2 and Gen 3 panels are not compatible with Gen 1. The top and supporting panels of Gen 2 and 3 have a smooth corner, which differs from the sharper corners of the previous generation.  Additionally the supporting panel and side panels contains a second tab, which is incompatible with Gen 1.  We will continue to support replacement panels, sides, and artwork services for BNB Fightstick Gen 1 models.

Gen 2 panels will now ship with a slimmer 3mm top panel for snaputton compatibility. Gen 3 top and support panels are compatible with Gen 2, and vice versa.

The bottom two panels of the BNB Plexi Fightstick consist of the bottom panel and supporting panel. The bottom panel protects custom artwork (if the panel is clear), or can either have no artwork or partial artwork for a view of the internal case. The supporting panel sandwiches the paper artwork between the bottom panel. The supporting panel is .177" (4.49mm) thick, while the bottom-most panel is a slimmer .125" (3mm) thick. Both possess screw holes for use with Set of 8 Bolts for BNB Fightsticks. The bottom is complemented with a Set of 4 Feet for BNB Fightstick.

Pre-Wrapped in Paper or Film Backing

The panels are cut from acrylic sheets with protective brown paper or blue plastic film.  You may see scratches or wear on the paper or film as the sheets are cut and transported from the acrylic manufacturer to us, and should not appear on the plexiglass once removed.  To remove the film, use a fingernail on any available corner and proceed to pull away at the backing. The paper or film does not have adhesive and should not leave residue on the plexiglass.

BNB Assembled Dimensions

Here are the Width x Length x Height dimensions of an assembled BNB Fightstick: