Bundle: American Wiring (For AFS Happ/IL Enclosure)

The American Wiring Bundle is designed to offer some of the fundamental harnesses and wiring you need to build out your AFS 14" Happ/IL Steel Case, Custom Art/Plexi Bundle, should you choose a Suzo Happ or Industrias Lorenzo lever and buttons. You will need to strip at least 2-3mm from the ends of the wire's covering to expose the metal, then install into terminal blocks on a Brook Fighting Board PCB of choice, or PCB that can accept signal and ground wires, plus 4-pin L3/R3/Touchpad connector.

What's Included?

Here's what's included with the American Wiring Bundle:

• 1 x 16pc 22 AWG Wire with .187 Quick Disconnect
  Connect these to your American style buttons and joystick, then to the Brook Fighting Board PCB or similar control PCB. 
  
  
• 1 x 30 Connection 22 AWG .187" Ground Daisy Chain Wire
  These ground daisy chains can be cut to the lengths you need for wiring your American style buttons to the PCB. In this case you need 4 connections for your joystick lever, and 8 connections for your buttons. Start with the 4 on joystick, then skip some connections to allow the daily chain to reach your buttons. Finally, connect the longer wire to the ground terminal on your PCB.
  
  
• 1 x 3pc 22 AWG Wire with .110 Quick Disconnect - Random Colors
  24mm option buttons fit the back of the AFS HAPP/IL steel case.  Use these to wire the three Option Buttons that may represent Home/PS Button, Share/Select, and Start/Option. 
  
  
• 1 x 3 Connection 22 AWG .110" Ground Daisy Chain Wire
  Use this as the ground wire for each 24mm Option Button. Connect to the ground terminal in your PCB.
  
  
• 1 x 4-Pin L3/R3/Touchpad Button Harness for Brook Universal Fighting Board
  These represent the L3, R3 and Touchpad Buttons on a Playstation controller. This 4-pin button harness contains .110 terminals to connect to another three 24mm buttons, along with a ground wire. This all attaches to the 4-pin L3/R3/Touchpad connector on most Brook PCBs.