Spare 5-Pin Female Harness for Zero Delay USB Encoder PCB

Write A Review

1. Does it's job, but read further

   I too used this harness to add a Sanwa JLF into my Qanba drone. Would've worked perfectly, but unfortunately my Sanwa JLF's wiring was... wonky. Take this as a PSA: when you buy a joystick, stick to buying from FocusAttack so you know you're getting legitimate parts. Unknown on Nov 8th 2019

2. Great way to upgrade joystick to sanwa jlf

   Used this product to upgrade my stock Qanba Drone stick into a sanwa jlf. Makes the process easy as abc123. Just plug into the joystick and plug the end into the pcb. The wires are all white, but you can easily match it up since the connector specifically clips in the correct way. Andre on Aug 28th 2019

3. Works Great and Easy To Install

   Ordered this with Sanwa JLF joystick and made the installation process nice and smooth despite it being my first time modding a stick. Unknown on Jul 7th 2019

4. Easy installation

   This was super easy to attach to a Sanwa stick, and my Mayflash 500. The fact that it's 5 wires that are in one cable makes reduces the # of cables in the controller, and the connection to the controller seems far less fragile than connections to the microswitches that were included with the default hardware. Unknown on Jun 29th 2019

5. Can confirm: Works for Qanba Drones

   This made modding my Qanba Drone far easier by allowing me to use a Sanwa joystick. It fits perfectly and plugs both into the Sanwa stick, and the 5 pin area of the circuit board of the Qanba. Also a perfect length too! Nozohomie on Jun 12th 2019

6. Works great

   Ordered it for a Sanwa jlf to use on my qanba drone works perfectly and no need to solder it to the board Adrian on Aug 13th 2018

7. Putting a JLF into a Mayflash F500? You need this!

   If you're customizing a Mayflash F500, this little guy is the missing link you need to install your Sanwa JLF joystick. The JLF will come with a wiring harness, but the harness doesn't have the right connector on it for the F500. This cable connects directly to the JLF's pins and the F500's PCB and is the perfect length. I almost panicked when I realized that I didn't have the proper hookup, but one of the helpful techs at Focus Attack told me this was the ticket, and 75 cents later my project was finished. If you're working on a similiar mod, don't forget to throw one of these into your cart! TJ on Aug 9th 2018

8. Just what I needed!

   I was modding a cheap Qanba Drone with a Sanwa stick and this harness was exactly what I needed to install it without soldering. AhegaoButter on Jun 28th 2018

9. mayflash 300 JLF upgrade approved!

   used this to add a JLF to some mayflash 300s i was modding.
   
   worked great! Unknown on Apr 29th 2018

10. Needed this for sure

    Recently purchased the mayflash 300 and wanted to swap out the joystick with a Sanwa. This pin connector worked perfectly Skeezo on Apr 9th 2018