- Category
- FightSticks/Pads
- Joysticks
- Pushbuttons
- Spare Parts & Tools
- Hardware & PCB
- Electrical
- Customize
- Merchandise
- Sales & Clearance
- Pre-Order
- Brand
ORDER FULFILLMENT PROGRESS THIS WEEK [ INFO ]
Fulfillment catch-up progress for the week of April 5.
The 5-Pin wiring harness serves as a replacement for your original Sanwa or Seimitsu 5-pin wiring harness should it get damaged. This can often happen when modding your stick.
The harness' length is approximately 20 inches, or 19 inches of wiring.
Important |
The 5-pin harness can also be used with the Seimitsu LS-32-01 Joystick, LS-40-01 joystick, LS-56-01 joystick and all flavors of LS-58-01 joystick. To use, flip the connector (the white part) so that the tab lip is facing down instead of up. Seimitsu peripherals have the ground connection on the opposite side of the 5-pin PCB. Please see our the graphic below for a helpful wiring diagram. |
Works like it's supposed to, comes packaged properly and bundled up to save space. Great for installation on a Brook Board Mikaul on Jan 1st 2021
Just what I needed to finish my build! Quality was good and had no issues with a secure attachment to the JLF. This is much better than other brands I have used in the past. Highly recommended. Unknown on Sep 15th 2020
Worked like a charm for my LS-32. The extra length of wires were greatly appreciated. Unknown on Feb 19th 2020
Works like a charm no faults. Rj on Feb 5th 2020
Plenty of wire length and solidly built Dave on Feb 28th 2017
This is a nice sturdy connector with heavier gauge and longer wires than stock JLF harness. Jim on Sep 15th 2016
Useful cable for installing a sanwa or seimitsu joystick Luis Neves on May 5th 2016
Really liked the leads were longer than stock. Made the wiring easier. Unknown on Apr 7th 2016