Philmore .110" Non-Insulated Quick Disconnect Terminal (Box of 100)

Write A Review

1. does the job but flimsy

   does what its supposed to do collis watt on Apr 28th 2020

2. Its a box of terminals. :)

   Not really much to say about this beyond that. The cable housing is spacious enough for two cables with sleeve, making it an excellent choice for daisy chaining. 3 cables will fit, but with no sleeve. You can spreed open the housing to fit three cables with sleeve, but your milage may vary
   
   Make sure you have a good crimping too, and note the direction of the gap. If you crimp in the wrong direction, the housing will not close properly over your cables, and they may be loose. This is completely a case of user error, and not a fault of the terminals themselves.
   
   Crimping too many times will cause the housing to break. Also user error.
   
   If you do it right the first time, the cables will lock in and be immovable. Good luck on your custom wire job! GasBurglar on Dec 19th 2019

3. Gets the job done

   Easy to use--didn't need any special crimpers. I haven't had much experience with the other type but these were a cinch and look better than the hardware store terminals I've seen other modders use. Holds tight, gets the job done, and couldn't ask for more. Unknown on Aug 25th 2019

4. 5-star

   Does the job for the good price. The grip is good, it is tight, hard to plug in, meaning it is hard to unplug. I noticed the material is somehow fragile, but as long you don't crimp to hard, you will not break anything. Raf on Feb 4th 2017

5. There very good

   Easy to fix and the replacements are easy to install anytime I need new pieces I always get them from FA. Best place on the web including Amazon because they just sell you something FA are gamers who use it and kno what you want. Bebop on Dec 31st 2016

6. Works

   It works, however as most people have reported there is no tab to easily remove the qd from the prong. Be careful and hold as close as you can. Robert Gouge on Aug 15th 2016

7. DIY FTW

   If you're like me and your OCD acts up for messy wiring, these are perfect for that sexy cable management.
   
   Warning: a tool, time and elbow grease required if you're using this. Devanand Bhagwat on Jan 20th 2016

8. good disconnect

   This is good disconnect work just fine but you can't disconnect them quick you will need pin or tweezers.
   
   oddly i received the best 110" disconnect from china when i ordered joystick PCB they had small thing you can press then you can release the disconnect
   
   take a look at my build here
   http://forums.shoryuken.com/discussion/202789/acrylic-arcade-joystick-fight-stick-tek-innovations#latest mesharyHD on Oct 19th 2015

9. Does the job

   Does the job but is not of equal quality to other disconnects. There is no tab to depress that releases the hold. Instead you kinda just have to reef this thing on and off your buttons. If not careful you can very easily break the switch into the button. So works but be careful! Mike on Sep 1st 2015